Modify IPv6 RSMLT Peer Information

Edit the existing configuration for the RSMLT peer node in the cluster.

Procedure

  1. In the navigation pane, expand Configuration > IPv6.
  2. Select RSMLT.
  3. Select the Peer tab.
  4. Select a cell to change the value.
  5. Select Apply.

Peer Field Descriptions

Use the data in the following table to use the Peer tab.

Name

Description

IfIndex

Shows the route SMLT operation index.

Ipv6Addr

Configures the IPv6 address of the RSMLT interface.

Ipv6PrefixLength

Configures the IPv6 prefix length.

AdminStatus

Shows the administrative status of RSMLT on the peer.

HoldDownTimer

Defines how long the recovering/rebooting switch remains in a non-Layer 3 forwarding mode for the peer router MAC address.

The default is 0.

HoldDownTimeRemaining

Indicates the time remaining in the HoldDownTimer.

HoldUpTimer

Defines how long the RSMLT switch maintains forwarding for its peer. The value is a range from 0 to 3600 seconds or 9999. 9999 means infinity.

The default is 0.

HoldUpTimeRemaining

Indicates the time remaining in the HoldUpTimer.

OperStatus

Displays the RSMLT operating status as either up or down.

SmltId

Specifies the ID range for the SMLT.

VlanId

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

MacAddr

Configures the MAC address of the VLAN.

VrfId

Indicates the virtual router ID to which the peer belongs.

VrfName

Indicates the virtual router name to which the peer belongs.